ES Windows Window Replacement Nationwide | Sightline Windows & Doors Pembroke Pines

ES Windows Window Replacement: The Pembroke Pines Owner’s Guide

ES Windows window replacement in Pembroke Pines typically runs $340 to $780 per opening installed, depending on series, size, and whether the unit is impact-rated or non-impact. We stock ES Windows-compatible sashes, balances, and hardware for same-day replacement on most residential series found in Pembroke Pines homes built between 1995 and 2020. Most owners discover a problem when the sash won’t stay up, the lock won’t engage, or they feel air movement around a frame that used to seal tight.

Call (754) 219-8346

Which ES Windows Models This Applies To

ES Windows manufactures three residential lines you’re likely to find in Pembroke Pines: the 5000 Series (non-impact vinyl), the 6000 Series (impact-rated vinyl), and the 8000 Series (aluminum impact). The label is usually etched into the glass corner or stamped on the frame edge; look for “ESW” followed by a four-digit date code. The 6000 Series dominates in Pembroke Falls and other neighborhoods where post-2005 construction required hurricane-rated glazing.

Here’s where matching matters: ES Windows changed its sash balance anchor width in 2017. A 2016 5000 Series double-hung uses a 5/8-inch pivot bar; the 2018 equivalent uses 3/4-inch. Order wrong and the balance won’t seat. We carry both OEM anchors and verified aftermarket equivalents from Caldwell and Amesbury. For impact units, we spec OEM glass packages only; the Miami-Dade NOA certification travels with the original glass label, and substituting non-listed glazing voids the rating. Non-impact sashes? A quality aftermarket with matching U-factor and SHGC performs identically at roughly 15% less.

Sightline Windows & Doors Pembroke Pines is an independent service provider, not affiliated with ES Windows.

Before

After

Signs Your ES Windows Window Replacement Is Failing

• Sash drops or won’t stay open. The coil balance has lost tension or the pivot bar has cracked at the stress point. In Pembroke Pines, we see this accelerated by salt air corrosion on the balance shoe, especially in homes west of I-75 where the Everglades breeze carries higher moisture content.
• Visible fog between glass panes. The insulated glass unit (IGU) seal has failed. ES Windows IGUs from the 2010-2016 period used a dual-seal system that held well in dry climates but degrades faster in South Florida’s humidity cycles. The glass is done; it cannot be resealed to factory spec.
• Lock won’t engage or feels loose. The keeper has shifted due to frame expansion, or the cam lock mechanism has worn. Aluminum frames in Pembroke Pines move more than vinyl through summer wet season expansion; we often find the lock misaligned by 1/8-inch or more.
• Air infiltration at the sill or jamb. The weatherstrip has compressed or the sill track has worn a groove. ES Windows’ 5000 Series used a fin-seal design that flattens after roughly 8-10 years of daily operation in Florida UV.
• Cracked or chipped glass with impact rating. Any breach of the laminated layer compromises the hurricane rating. Even a small chip at the edge can propagate under pressure; the NOA requires full glass replacement, not repair.

Replacement Cost & What’s Included

The range reflects three variables: unit dimensions, impact rating requirement, and frame condition. A 32-by-54-inch 6000 Series double-hung in good frame condition runs toward the lower end. A 48-by-60-inch 8000 Series with corroded aluminum frame and stucco repair needs lands higher. Every quote we write itemizes parts, labor, and any frame remediation separately. Haven Clause 1: the measured survey and the written price are the same document. The 365-Day Done Right Promise covers the installation; glass carries the manufacturer’s warranty against seal failure.

DIY or Call Us?

An owner can safely inspect for the symptoms above and photograph the label for identification. What we don’t recommend: removing a sash with failed balances (it can drop suddenly), cutting tape or sealant on an impact unit (the lamination is under tension), or attempting to reglaze an IGU (factory vacuum and desiccant cannot be replicated on a truck tailgate).

The specific risk with ES Windows impact units is the anchor system. The 6000 Series uses a tilt-latch design that looks straightforward but seats with a specific angle; force it flat and the latch pin shears. We’ve replaced dozens of sashes where the owner got the old one out and couldn’t get the new one to lock in. Measure it right the first time. Everything else follows from that.

If you’ve got the label photo and the symptom description, call (754) 219-8346. We’ll confirm fit before we schedule, and we’ll bring the part verified against your series and year code.

FAQs